The Underfloor Heating Time switch (Danfoss FP975) located in your apartment’s hallway allows you to set ‘On’ and ‘Off’ time periods for your underfloor heating to suit your own lifestyle. 

The ON and OFF settings can be programmed for three time periods in any one day. 

Press PROG once until SET 1 CH ON TIME appears at the top of the display. Use the + or – buttons to set the time you want your heating to come on for the first time period of the day. 1:30 am, 1:31, 1:32, 1:33, back 1:32, 1:31, 1:30

Press NEXT ON/OFF to set the OFF time for that first time period it will display SET 2 CH OFF TIME. Time 7:30 am, use the + or - buttons 31, 32, 33, back 32, 31, 30.

Press NEXT ON/OFF for the ON time of the second time period of the day, which will display as SET 3 CH ON TIME. Time 8:30am. Press NEXT ON/OFF for the OFF time of the second time period of the day which will display as SET 4 CH OFF TIME. Time 8:30am. Note if you don’t want to set a time for the second time period leave the off time the same as the on time. 

Press NEXT ON/OFF for the ON time of the third time period of the day, which will display as SET 5 CH ON TIME. Time 8:30am. Press NEXT ON/OFF for the OFF time of the third time period of the day which will display as SET 6 CH OFF TIME. Time 8:30am. Again if you don’t want to set a time for the third time period leave the off time the same as the on time. 

You have now done the settings for CH which is Zone 1 (Lounge and Kitchen). Press PROG and the display will show SET 1 HW ON TIME. 

Go through the same procedures as you did for CH/Zone1. On completion of HW/Zone2 settings press PROG to return to RUN mode. 

The current time appears and the colon in the display begins to flash. The unit is now in RUN mode and will control your heating according to your pre-set times. 

Press the PLAY arrow to view the video